![]() ![]() You can probably do this just by changing the router's IP address to 192.168.5.1 and leaving the subnet mask alone (set at 255.255.255.0). Your Linksys router should have a way, in its configuration page, to set the IP address range to 192.168.5.1 through 192.168.5.254. So when you specify a NAT as having a gateway at 192.168.1.1 and a subnet mask of 255.255.255.0, that means IP addresses 192.168.1.1 through 192.168.1.254 are valid on that NAT due to the routing rules that are implied by the subnet mask, all traffic not occurring in this range is considered non-routable by the layer 3 switch within the router. Typically, in almost all cases, the subnet mask is 255.255.255.0, which means that you're using one number for the first three octets (the 255s), and all numbers for the last octet (the 0). IP address ranges for private subnets (NATs) are specified by a subnet mask, which determines the valid range of IPs that are assigned. I've also tried to disable internet access from my external modem so the router didn't have internet access.ĭoes it have anything to do with the fact that the device is on 192.168.5.* and the network "generated" by the router is 192.168.1.* and therefore can't see it? I have tried pinging the device from a laptop that's connected wirelessly to the network, and from a stationary computer that's connected with cable directly to the router. 3) Enter the command ‘ipconfig’, in the command prompt. 2) Once you enter the CMD command, the command prompt having a black screen will open up. 1) Go to the Start menu of the taskbar and type CMD in the search box. I also can't see the device when I go to the DHCP clients list in the router settings. To find out the default IP Address of a router please follow the steps given below. ![]() Change the computer's LAN settings to use the specific IP of the device.Does it have anything to do with the fact that the device is on 192.168.5.* and the network "generated" by the router is 192.168.1.* and therefore can't see it?.Why do I not receive a response from the unit when I ping 192.168.5.124?.I'm not really an expert in home networking, so my questions are: The computers on the network have IP addresses 192.168.1.100 and up. My Linksys router has the IP address 192.168.1.1 (pretty standard). Step 3: Set the Configuration View to Manual in. I am currently having problems seeing this device on my network. To access a router, you must know the routers IP address and the administrative users password and username.To request a connection to the. NOTE: The look and feel of the web-based setup page may vary depending on the model of your Linksys router. I must connect to it via an ethernet cable and then use Modbus for communication. ![]() I have this board with IP address 192.168.5.124 (can't be changed). ![]()
0 Comments
Leave a Reply. |